Pushpull Meter
is a force measuring instrument for both Push and Pull. There
is ZERO ADJUST, An additional red Pointer retains the maximum
reading encountered.
It is a force
measuring instrument for both push and pull. RED POINTER
retains the maximum reading encountered. By rotating it anto-clockwise
set it to zero again.
Because of
gravity the METER when held inclined ( or upside down) shows
reading different than when held vertically. To nullify gravity
effect, turn ZERO ADJUST holding the METER the same way as will
be held while measuring.
Spot
calibration gives better results. Apply standard force ( the
one nearest to the force to be measured ), and with the ZERO
ADJUST make the instrument read the value of the standard force.
METERS with
capacities below 2 Kg. may require a light tap to overcome
static friction.
To prevent
damages to inside parts, hold the pushing/pulling ROD firmly
while changing accessories at its ends.
Do not push
the PULL END or pull the PUSH END. It has overload capacity of
30% METER can be clamped on SQUARE BODY.
